Tape Duplication Systems  / Tape Duplicators

Tape Duplicator 80 (TD80)
PV1 Range


TD80

Tape Duplicator 80 Delivering...
  • Easy Connectivity
  • Multiple Copies
  • Mix & Match Media
  • Rated at 80MB/sec*
  • No data from the tape being copied is retained within the unit (block-by-block copy), making these units ideal for use in high security locations

...for Tape Drives, Libraries, and Stackers

The Avax Tape Duplicator 80 is a high performance, offline, Ultra fast wide SCSI controller that provides either 1 to 1 copying, 1 to 'n'  copying from a single master tape using a sequential stacker as the target device, or 'n' to 'n'copying with stackers as both source and target.

Using a sequential stacker, the number of copies produced is only limited by number of tapes in the stacker. Duplication of mixed tape technology is standard, as is stacker to stacker duplication .

The TD80 is available as a stand alone desk top module.  Units are available in all the popular drive formats.  The TD80 uses "block by block" copying, making it ideal for locations where security demands that tape data not be stored in memory after copying is completed.

For more information on the TD80 family of tape copiers, download a copy of the TD80 Data Sheet  Download Acrobat Reader

*80MB/sec burst, >50MB/sec sustained 




PV1 RANGE

  • Low cost tape duplication system
  • Rated at 10MB/sec
  • No data from the tape being copied is retained within the unit (block-by-block copy), making these units ideal for use in high security locations

Tape Copiers
Disaster Recovery - Off-site Security - Data Distribution ; our copier solutions are designed to meet most data duplication and distribution requirements.

COPY CONTROLLER
PV's SCSI controller can make block by block copies of any format of tape in a variety of ways. Because it is a stand-alone device the copying process is much more efficient than using software on a computer system and does not require a high value operative.




TOWER COPYSTATION

Towers are stand-alone units for producing multiple copies of the same tape. Any format of drive can be accommodated, with one master drive and one or more copy drives below for concurrent operation.

Models available: 1-1, 1-2, 1-3, 1-4, 1-5, 1-6.




AUTOLOADER COPYSTATION

The PV controller converts a two drive library/autoloader to produce multiple single copies at high speed. It partitions the slots of the library and operates the robotics to load each cartridge in turn. Master tapes are loaded on one side whilst blank tapes are loaded on the other and the copier will step through the tapes automatically. The operation is very simple and is perfect for unattended operation.




Tape Duplication Product Range

Tape duplication is a simple task with an Off-Line Copy Station. Copies for Disaster Recovery or Distribution can be achieved on a wide range of tape technologies using the front panel display provided.

Off-Line Copy Station Features:
Copy, Copy and Verify, Verify and Display Drives.

Display Features:
Pass or Fail Results, Remaining Tape Capacity, Compression Ratio, Transfer Rate and Error Detection.

Units are available for 1-6 Slave drives.






Home | Products Index | Contact Us





Please see our associate site at www.avax.com
for all your other tape backup and
data interchange requirements.





Copyright © 2000 - Data Encryption Canada
A Division of Amasak International Inc.
PO Box 542 · Hillsburgh · Ontario ·N0B 1Z0 · Canada
Telephone Inquires: 647-367-1039
Toll Free: 800-443-4542
International Number: +883-510-001-125830
Facsimile: 647-438-2242
Email: sales@dataencryption.ca